PlayStation 4™ Adapter Button Layout and Instructions

We now offer a PlayStation 2™ to PlayStation 4™ adapter, it requires one of our PlayStation 2 or 5in1 X-Adapters, available purchase options here. This adapter will also allow you to use many other PS2 gamepads/controllers on your PS4 or PS3 console.

Click here to purchase a PS4™ adapter for the X-Arcade™

IMPORTANT NOTES:

PS4 2-PLAYER SETUP:

Once you have 2 accounts, you will want to do the following to get setup:

  1. Player 1 side: Press Share+Option simultaneously to initialize the controller, this may take you to the login/Shut Down or menu screen (this is normal). Press Share+Square or Share+Triangle to get the controls working, then log into your main user account.
  2. Player 2 side:Press Share+Option on the Player 2 side of the controller, then Select+Square or Select+Triangle and log into the secondary/guest account.

PS3 2-PLAYER SETUP:

Just connect them to the PS3 to play. You can reassign controllers at any time, (using the controller you want to reassign) go to "Settings" in the XMB, go to "Accessory Settings", and choose "Reassign Controllers". Simply change to the number you prefer.

image

Hold the Share button and tap the Option button once = tapping the PS button on a PS4 gamepad. To exit a game, while continuously holding the Share button press Option and then immediately (While still holding Share) press Square or Triangle.

There is also PS button on the PS4 adapter itself.

Instructions and the full list of functions available here.

Turbo Mode (rapid fire):

If you hold any button and press Option it will set that button to turbo mode (red light on PS4 adapter comes on). To turn it off, hold the same button again and press Option again (light on adapter goes back off, unless other buttons are still set to turbo mode). Unplug the adapter from the console and plug it back in to reset/turn off turbo mode for all buttons.

Firmware Upgrade:

You can upgrade the firmware to the newest version for new features and compatibility and will need to do this if your adapter is timing out (stops working after a few minutes of play).

Download Firmware Upgrade (choose download for "PS2 to PS3/PS4")

Troubleshooting:


Source article: <https://support.xgaming.com/support/solutions/articles/12000011139-playstation-4-adapter-button-layout-and-instructions>

Player 2 buttons repeat Player 1: distinguish dual-stick mode from two-player setup

Scope: the legacy PS2/5-in-1 to PS4 adapter chain described by this article, not original-XR Gen2 wireless mode, XR MAX or every Brook product. In a reviewed PS4 Pro case, Player 2's stick responded but its buttons could not complete the second account login; after a cable swap, some controls instead repeated Player 1. PC XInput testing worked, and repeated adapter swaps and restarts had not restored independent players.

Support raised dual-stick mode as a possible discriminator. The customer subsequently confirmed that toggling out of dual-stick mode restored operation. The history did not record the exact toggle combination or isolate why the setting was active. Do not invent a shortcut, infer a factory defect or assume a replacement adapter is required from this symptom alone.

Identify the exact controller board and every adapter in the chain, then check that chain's documented dual-stick/two-player setting with support. Keep the Gamepad-versus-Wheel setting and separate PS4 account initialization checks above distinct. After a supported mode change, verify that each player can log into a different account and that both players' buttons remain independent in the intended game. If they still duplicate or cannot validate login, report the mode, account behavior, PC test and swaps already completed instead of repeating the same swap.

The PS4 adapter's red LED is normally off unless Turbo is enabled, as noted above; an unlit adapter LED alone does not prove loss of power or failed firmware. A keyboard-layout test must use the appropriate Mode 1 baseline; working XInput on PC is a different test.